Summer Starts Here - Save up to 70%
Trailer Wiring Harness Installation - 1998 Mercury Villager- Video
Today on this 1998 Mercury Villager were going to install part number 118175KIT. This is a wiring harness that we have to hard wire to the vehicle. Go ahead and open the back hatch and get access to the wiring. There is a panel on the left hand side of the vehicle that well remove to get access to the wires. First well go ahead and remove the sheath to the wires that are going to the tail light on the left hand side. With the wires exposed well go ahead and unplug the wire harness from the tail light. more
11/6/2012 3:32:51 PM
Trailer Wiring Harness Installation - 2002 Mercury Villager- Video
Ok, today we are working on a 2002 Mercury Villager. We are going to install part number 119175, T-one 4-pole wiring harness. I am going to go ahead to the inside of the vehicle and remove the side compartment door. You can see this also gives us access to our taillight wires and an area to mount our module. I am going to go ahead and repeat the same process on the passenger side of removing the cover. Ok, now that we have our cover doors opened up, what we are going to do is remove this trim panel piece so that we can route our wires from the driver side to the passenger side. Ok, now that we have our threshold piece removed, what we are going to do is take out this screw, or knob, which is a cargo hook, on the bottom and the top so that we can pull this panel away from the body of the vehicle to slide our wires underneath. You can see this will now give us plenty of access to feed our wires underneath the trim. 0:57 more
7/14/2011 12:34:22 PM
Trailer Wiring Harness Installation - 1997 Mercury Villager- Video
Today on this 1997 Mercury Villager we are going to install wiring harness part number 119175 from Tow Ready. We are going to wire up the harness mainly on the driver side of the vehicle. We are going to do these four wires and hook them up to the inside behind the taillight. And we are going to take our green wire and we are going to run it underneath the plastic to the other side to make our connection to the turn signal there. We will go ahead and temporarily take off the threshold here. This usually just pops right off. We are going to remove these doors, one on each side. Look behind the taillight and you will see the connection point with four wire going to it. Disconnect that and we can find our circuits for our converter box. And we are just going to peel away the electric tape so we have access to our wires. 0:50 more
3/4/2011 9:56:41 AM
Filter Videos
Filter Videos
